Tuesday, November 20, 2012

{Tutorial} Turkey Hair Bow

I had the privilege of guest posting at Sugar Bee Crafts last week!  I love Mandy and her blog, so this was an honor :)


I decided to make my kiddies custom Thanksgiving turkey outfits this year and my daughter needed a bow to go with it!  This project is very simple and was finished in 20 minutes {including stopping to snap pictures!}.

You'll Need:

5 colored 3" pieces of ribbon {for feathers}
14" brown ribbon
tiny piece of orange and red ribbon
2 small googly eyes
glue gun & glue


Gather your supplies and cut all ribbons to size.  For the brown ribbon, you need a 2", 3", 4", and 5" piece of ribbon.

Start by assembling your feathers.  Dap a small spot of hot glue on the top of one end of the ribbon.  Loop the other top end to make the tops touch together.  The ends should be perpendicular to each other.  This gives the feathers a little curve.  Do this will all 5 pieces.


Now onto the body.  We are using the 3", 4", and 5" pieces for the body.  And we are gluing them a little differently than the feathers.  This time, we want an even, complete circle.  Put a dab of hot glue on the top of one end of the ribbon and attach the bottom of the other end to create a circle.  Repeat with all three pieces.


Glue the three circles together at the spot where they are already glued.  You now have a turkey body!!!


Let's work on the head!  Using your 2" piece, create another circle keeping the two end pieces perpendicular.  


Put a dab of glue on the curve of the inside of the ribbon.  You are basically making a triangle head for the turkey.  Do this on both sides.


Next add the eyes, beak, and gobbler with hot glue.


You should now have 5 feathers, a body, and a head.  Let's add the feathers to the body.  Start by gluing the center feather at the spot where the body is glued together.  


Then arrange and glue the other feathers on.  They look best if overlapped some.


Glue the head on at the same spot where the body is attached together.  You now have a turkey!


I like to use alligator clips for my hair bows, but you can attach it to a french clip, head band, or hair tie.  I also like to cover the tops of the alligator clip if it will be visible at all.  

To cover it, glue one end of the ribbon under the top part that you squeeze {technical terms, I know.}.


Glue along the whole top and wrap the ribbon under the top piece and glue again.


Glue the turkey onto the clip.  


{Hair Bow Tip #1 - Use your blow dryer to get rid of all of those silly, little hot glue strings!}

{Hair Bow Tip #2 - Seal the ends of your ribbon by heat sealing or using No Fray that you can purchase at any craft store.}

That's it! 













Thursday, November 15, 2012

{Tutorial} Turkey Thanksgiving Outfit

I had the honor of guest posting at The Ribbon Retreat blog last week!  This was such a fun, quick project.  I couldn't believe how simple the skirt was to make.  I'll definitely be making more circle skirts!

If you have a blog and are interested in guest posting for them, I highly recommend it!  It was a pleasure working with them AND they provided the supplies for the project.  


Thanksgiving is one of my favorite times of the year!  I love the yummy food, delicious desserts, and, of course, quality time with family.  And what best represents Thanksgiving?  TURKEY!


I'm going to walk you through how to make this custom outfit yourself!

You'll need:

7 fat quarters
shirt
piece of elastic {mine was 1″}
matching thread
fusible web {I like Heat N Bond Lite}
turkey pattern {download here}

{my fabric choices were Raspberry Medallion in Zoe for Studio E, Yellow Seedling Star in Garden-Go-Round by Studio E, Green Swirls in Good Life for Riley Blake, Orange Essential Dots, Slate Josephine’s Bouquet in Cameo for Free Spirit, Coral Vintage Ironwork in Sunset Garden for Michael Miller, and Brown Circles in Decadence for Riley Blake, in order}
Let's start with the shirt!

Download and print the pattern piece HERE.

Trace the pattern pieces onto the paper side of your fusible web.  Cut out roughly around the edges leaving a little room to cut the actual piece later.


Iron onto the wrong side of your fabric following the instructions with your fusing product.


Now, cut the pieces out on your pattern lines.  Peel off the paper on the backs and begin to arrange the pieces and iron down each layer as you go.


Machine stitch 1/8" from the edge of each piece of the turkey.


Pull the loose threads to the inside of the shirt and tie them off to prevent unraveling.



For other appliqué tutorials, check out these: Disney Cars, Monthly Momento Onesies, and Mickey and Minnie tees.

Now onto the skirt!


You will need a few measurements and a little bit of math, but I'll walk you through it!

First you will need a waist measurement.  My 5 year old daughter's was 19," but she's a peanut for her age.  The other measurement that you'll need is skirt length.  I measured one of her skirts that hits an inch or so above the knee.  I used 10."

To calculate the radius to draft your pattern, you'll need some math :)  {Fun Fact:  I was a math minor in college...too bad I had to google my equations for this pattern!}

Circumference = 2*pi*radius 
{or}
Radius = Circumference/2*pi

The Circumference is your waist measurement + 2 inches to allow for some gathering in the waist.  For me:
Radius = 21/6.28 = 3.34"

Grab a large piece of paper {or several letter sized pieces taped together}.  Start from the top left corner and measure and mark several spots 3.34" from the corner.  Since my ruler wasn't very precise, I just marked mine at 3.25."  Connect the lines to create a semi-circle.  If you have a compass, you could use that much easier :)


Now to figure out the radius of the bottom curve, add your skirt length to the radius of the top circle. 

Waist Radius + Skirt Length = Bottom Hem Radius

For me:
3.25 + 10 = 13.25

Measure 13.25" from the top left corner and connect the dots again.  This makes a pattern piece for one quarter of the skirt.  If you are making a regular circle skirt with one solid piece of fabric, check out this tutorial.


I wanted to piece together my six fabrics used for the turkey feathers to make the skirt.  So I needed a piece for 1/6th of a circle.  To do this, I needed to make a piece that was 2/3rds of this piece.

Using your ruler, draw a line from one end of the arc to the other and measure it's length.  Divide that measurement by 3.  {For me, 4.67"/3 = 1.55ish inches}.  Split your line into thirds.


Do the same with the bottom arc. {For me, 18.75"/3 = 6.25"}


You should have two marks on each line that divides the lines into thirds.  Using your ruler, draw a line from the top left corner through the second mark in both of your lines.


Cut along this line and along the arcs to create your pattern piece for 1/6th of the skirt.  Use this piece to cut out one piece from each fabric.


With right sides together, sew the pieces together to create a solid circle.  Either serge or zig zag the unfinished edge of each seam to prevent the fabric from unraveling.


Once finished, serge or zig zag the top and bottom of the skirt.


At this point, you can finish the bottom hem as you choose.  I left the edge zig zagged and slightly frayed to give a more rustic look.  You can also iron under and hem the edge or add biased tape.

Next, cut your piece of elastic.  You will want a little room, so add 1 inch to your waist measurement.  I cut my piece 20."  Sew the ends of the elastic together to create a circle waistband. 

To pin your elastic to the skirt evenly, start by folding the elastic in half and the skirt in half and pinning the ends together.


Next, fold evenly the other way and pin the skirt in 4 places total.  Do it once more for the skirt to be pinned in 8 places.


To make sure the skirt gathers evenly when sewing the waistband on, hold the elastic at two adjacent pins and stretch it to the same length as the section of skirt that you are sewing.  Continue to do this until the waistband is sewn on.

Next, stick it on your girl and let her twirl!!


Today I'm Visiting...

I'm guest posting over at Sugar Bee Crafts today!! Come see me :)
   

Wednesday, November 7, 2012

Tuesday, November 6, 2012

Hodge Podge

I've got a few things for you today! First of all, don't forget about the Giraffe Grins Holiday Pillowcase drive! It's not too late to participate and donate fabric or pillowcases. Just let me know via email or comments here if you are planning to participate!


 Second, I'm over at The Ribbon Retreat's blog sharing a super cute Thanksgiving outfit tutorial. This was a super fun project to do and only took about 1.5 to 2 hours total to make. I'm planning to add a few more things to the skirt to dress it up a bit, but it's adorable as is!


Lastly, we got a few new family pictures taken with Matt's whole family and I love them so much that I have to share a few!  If you live in Cincinnati or Northern Kentucky, check out AC Photography.